Engine controls

463 Views 5 Replies 3 Participants Last post by Ste.c, Aug 16, 2010

Ste.c

Discussion Starter · Aug 1, 2010

Just a quick question, I'm moving the centre console on my 15' boat forward and will need to extend the engine controls to do so. The origional Tohatsu ones I had were very stiff and hard to move, probably due to age maybe? The engine is a 40hp Tohatsu auto mixing 2 stroke. Do I need to buy a Tohatsu control box/cables or can I get a compatible setup? Any advice would me much appreciated.

Cheers

Steve

Save

1 - 1 of 6 Posts

TomBettle

· #5 · Aug 16, 2010

BrianR said:
When you open the old box to remove the cables, just give it a good clean, look for any obvious problems and give it a good greasing when you assemble it.

Make sure the cable runs are as straight as possible with minimal turns and NO tight turns.

Save

1 - 1 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month