World Sea Fishing Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
215 Posts
Discussion Starter · #1 ·
I have a gemini lead mould and ive lost the printout
which gives you a guide on how far to put the stopper/screw
to get different size weights,can anyone email me a scan of
theres or measure the different depths from the bottom of
the mould for 4,5,6,7oz so i can mark it on
Thanks a lot lads
ian
 

·
Registered
Joined
·
1,501 Posts
Hi Ian,
From the bottom where the screw ajuster goes through, measure 2cm that will give you a 5oz weight 1.5cm =6oz 1cm =7oz and the full mould 8oz.
Hope this helps. Ive measured the marks on mine and Ive found them to be reasonably accurate although minor adjustments can be made if needed
Ian
 
1 - 4 of 4 Posts
Top