World Sea Fishing Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
13,345 Posts
Baz, you`ll get by fine with a basic guide put on with hot melt glue, no need to thread wrap it unless you buy something like an alconite tip which has a foot. If you decide on a roller exactly the same.

Get the right diameter tube 3, 4, 5mm whatever, cut slivers of hot melt and put them into the tube, heat the tube, stick it on, line up immediately, job done a minute or two later.

Dont rub the hot melt onto the blank as all that happens is it rubs off as you push the tip on and you get bad adhesion.

Should cost you about £3-£5 max for the tip, depending which one you choose.

:unsure: :unsure: :)
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top