World Sea Fishing Forums banner
1 - 2 of 2 Posts

·
Banned
Joined
·
781 Posts
remove the magnet end plate, pull out the spool from the reel cage, remove the spindle, then remove bearings form the spool. then soak bearings in lighter fluid for 30 mins remove from fluid allow to dry for ten mins, then repeat again soak in lighter fluid for a further 30 mins then remove and allow to dry on a piece of kitchen towel for 30mins somewhere warm. make sure that they are completely dry then apply a very small drop of bearing oil to each and allow it to soak in before re-assembling the real. the bearing oil i would use is yellow or red rocket fuel depending on how fast you want the reel to run yellow being faster than red.
 
1 - 2 of 2 Posts
Top