World Sea Fishing Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
1,487 Posts
.If you use a clove hitch around a rubber band then cut away the excess rubber leaving about 1/4 inch on the line then a bead under it ,the rubber goes through the rod rings no problem and you can fish as deep as you like, when you pull the rubber off,it leaves the line in tact without any knot.

the easy way to tie a clove hitch is to take your line and make 2 loops in it,put the front loop behind the back one and put your rubber band through the 2 loops and pull tight,should take less than 10 sec,s try it
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top