World Sea Fishing Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
51 Posts
Discussion Starter · #1 ·
Had a front engine mount collapse on the boat must have been like it some time, lifted the boat out first time in five years to give it a paint job and a mate pointed out the shaft out of line, on looking closer no cutless bearing and the thread had gone on the end cap bearing, took the shaft out ok which was worn in a couple of places, which left the stern tube to remove to have a new thread fitted and look for any other problems. The shaft is just under two mtrs long so now i have been a week trying to dig out the stern tube drilling grinding and chisleing the further i go back the resin gets thicker any sugestions to get it out ta Rob.
 
1 - 3 of 3 Posts
Top