World Sea Fishing Forums banner
1 - 13 of 13 Posts

·
Registered
Joined
·
172 Posts
Simples - put your fishing line thro the loop of wire that the stops are on - then slide the stop off the wire over the loop onto your fishing line.
 

·
Registered
Joined
·
15,511 Posts
And make sure that you wet the line before you slide the bait stop from wire to line, I use 40 lb mono for some ( not all ) snoods, and before I wet the line it snapped the wire, wetting helps it slide on smoothly.

Dave.
 

·
Registered
Joined
·
1,057 Posts
lee were were you live in dorset cheers jason
 

·
Registered
Joined
·
1,057 Posts
i live in weymouth to if you want any help with your rigs and that give me a pm or message me and i can show you if you like
 

·
Registered
Joined
·
15,511 Posts
I reuse them, I take a large needle, thread some whipping thread that has been doubled through the needle, then I push the needle through the rubber stop , pull the thread through and you can use them again as you did when they were on the wire.
A bit fiddly and to be honest it is just as easy to but some new ones.

Dave
 

·
Registered
Joined
·
976 Posts
Am I doing it the hard way by using a stop knot and bead or sequin just above the hook? Its way cheaper than the stop beads. :eek:

Sent from my GT-S5830 using Tapatalk 2
 
1 - 13 of 13 Posts
Top